 turbo tie rod wrench |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dax1969 |
 Oct 14 2020, 03:58 AM
Post
#1
|
|
Member  Group: Members Posts: 387 Joined: 10-March 14 From: belgium Member No.: 17,103 Region Association: None 
 |
Hi guys,
I am going to install the turbo tie rod kit on my 74. Read all I could find but had a question on the flat key to be used. The one on autoatlanta is square but I can't seem to find them here. Would the below "rounded" one work ? Size is 32 mm so that should be correct thks Dax Attached image(s) 
|
   |
 
|
  |
Replies
| bdstone914 |
Oct 14 2020, 11:30 AM
Post
#2
|
|
bdstone914 Group: Members Posts: 4,906 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
QUOTE(dax1969 @ Oct 14 2020, 02:58 AM)  Hi guys, I am going to install the turbo tie rod kit on my 74. Read all I could find but had a question on the flat key to be used. The one on autoatlanta is square but I can't seem to find them here. Would the below "rounded" one work ? Size is 32 mm so that should be correct thks Dax It needs to be a thin 32mm the flat part of the turbo tie rod is very narrow. A crescent wrench will not work |
 |
|
Posts in this topic
dax1969 turbo tie rod wrench Oct 14 2020, 03:58 AM
betz
Hi guys,
I am going to install the turbo tie rod... Oct 14 2020, 09:44 AM 914e Snap-on sells thin blade wrenches, of course at a ... Oct 14 2020, 12:45 PM Luke M Check your local bike shops. I purchased one from ... Oct 14 2020, 12:50 PM
digit3
Check your local bike shops. I purchased one from... Oct 14 2020, 01:11 PM mbseto Surprised you can get those anymore. Everyone use... Oct 14 2020, 02:25 PM mepstein
Surprised you can get those anymore. Everyone us... Oct 14 2020, 04:56 PM iankarr Got mine on amazon...
Park Tool Headset Wrench...... Oct 14 2020, 02:35 PM Olympic 914 I went to a local bicycle shop and used their wren... Oct 14 2020, 06:42 PM bigkensteele I don't recall who, but a member here was sell... Oct 14 2020, 08:30 PM mgp4591 I bought my set years ago to replace Chrysler inne... Oct 14 2020, 11:20 PM dax1969 The one shown in my picture is actually used for b... Oct 15 2020, 01:38 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 10:14 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.