 turbo tie rod wrench |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dax1969 |
 Oct 14 2020, 03:58 AM
Post
#1
|
|
Member  Group: Members Posts: 362 Joined: 10-March 14 From: belgium Member No.: 17,103 Region Association: None 
 |
Hi guys,
I am going to install the turbo tie rod kit on my 74. Read all I could find but had a question on the flat key to be used. The one on autoatlanta is square but I can't seem to find them here. Would the below "rounded" one work ? Size is 32 mm so that should be correct thks Dax Attached image(s) 
|
   |
 
|
  |
Replies
| mbseto |
Oct 14 2020, 02:25 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,253 Joined: 6-August 14 From: Cincy Member No.: 17,743 Region Association: North East States |
Surprised you can get those anymore. Everyone uses sealed bearings. My old bicycle toolbox is filled with all the various BB sizes needed to repack all the bearings on the old Cannondale.
|
|
|
|
Posts in this topic
dax1969 turbo tie rod wrench Oct 14 2020, 03:58 AM
betz
Hi guys,
I am going to install the turbo tie rod... Oct 14 2020, 09:44 AM bdstone914
Hi guys,
I am going to install the turbo tie rod... Oct 14 2020, 11:30 AM 914e Snap-on sells thin blade wrenches, of course at a ... Oct 14 2020, 12:45 PM Luke M Check your local bike shops. I purchased one from ... Oct 14 2020, 12:50 PM
digit3
Check your local bike shops. I purchased one from... Oct 14 2020, 01:11 PM mepstein
Surprised you can get those anymore. Everyone us... Oct 14 2020, 04:56 PM iankarr Got mine on amazon...
Park Tool Headset Wrench...... Oct 14 2020, 02:35 PM Olympic 914 I went to a local bicycle shop and used their wren... Oct 14 2020, 06:42 PM bigkensteele I don't recall who, but a member here was sell... Oct 14 2020, 08:30 PM mgp4591 I bought my set years ago to replace Chrysler inne... Oct 14 2020, 11:20 PM dax1969 The one shown in my picture is actually used for b... Oct 15 2020, 01:38 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 10:17 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.