 Weltmeister oil trap. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Keith914 |
 Mar 14 2017, 09:34 PM
Post
#1
|
|
Member  Group: Members Posts: 248 Joined: 29-April 16 From: Laguna Beach, California 92651 Member No.: 19,948 Region Association: Southern California  |
I attempted to install this new Weltmeister sump oil trap today, but concluded it cannot be installed with the existing stock oil screen. Is this correct? Otherwise I believe installation of this oil trap replaces both the screen and taco plate -- from the top down: O ring, pickup extension, taco plate size gasket, oil trap, copper squash washer, bolt, all shown in the pic, correct?
Attached image(s) 
|
   |
 
|
  |
Replies
| 914werke |
Oct 26 2020, 01:50 PM
Post
#2
|
|
"I got blisters on me fingers" Group: Members Posts: 10,156 Joined: 22-March 03 From: USofA Member No.: 453 Region Association: Pacific Northwest 
|
While this part doesn't exist anymore there are a few still floating around to be found on the secondary market.
Im finding the racers are interested in them due to their (steel) construction and the ease with which they can be welded/plumbed for a scavenge line. For everyone else I offer an updated Aluminum version that has added benefits detailed in the member vendors section / on my store. |
|
|
|
Posts in this topic
Keith914 Weltmeister oil trap. Mar 14 2017, 09:34 PM
Dave_Darling Correct. The instructions should mention omitting... Mar 14 2017, 10:29 PM brant On those welt kits I have also opened the oil slot... Mar 14 2017, 10:36 PM falcor75 Be very carefull tightening the bolt.....you dont ... Mar 14 2017, 11:17 PM
Mark Henry
Be very carefull tightening the bolt.....you dont... Mar 15 2017, 06:33 AM Keith914 Thanks for all of your comments. I will open up th... Mar 15 2017, 08:49 AM Dave_Darling Nine. As in, less than 10 lb-ft. That's why ... Mar 15 2017, 09:50 AM Keith914
Nine. As in, less than 10 lb-ft. That's why... Mar 15 2017, 10:11 AM Mark Henry So that would be 108 inch pounds. An inch pound to... Mar 15 2017, 11:41 AM RobW Over clean the area and mount it straight. +3 on t... Mar 15 2017, 12:09 PM maf914 :hijacked:
Can anyone recommend a good inch-poun... Mar 15 2017, 04:09 PM mgphoto
:hijacked:
Can anyone recommend a good inch-pou... Mar 15 2017, 07:26 PM old914dog Drill for safety wire......it doesn't cost muc... Mar 15 2017, 07:45 PM tjtryon I know, I know, I'm resurrecting an old post.
... Oct 26 2020, 11:01 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th June 2024 - 10:41 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.