Tie-Rod Ball joint, How do you tighten them? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Tie-Rod Ball joint, How do you tighten them? |
frostyf |
Nov 7 2020, 07:28 PM
Post
#1
|
Member Group: Members Posts: 154 Joined: 27-March 14 From: VA 23455 Member No.: 17,168 Region Association: MidAtlantic Region |
Hopefully someone with a bit more experience can give me a steer on this:
I've changed out my tie rods for turbo tie rods and have re-assembled them. Question is how do you tighten them to the required torque (manual says 33 ft lbs). The ball joint bolt spins as soon as any torque comes onto it (with either my electric hammer wrench or socket). There's no hex socket in the top to hold the ball-joint bolt whilst the nut is tightened? Is there some special way to fit them and tighten them to the correct torque? Thanks for any advice! Nick |
aharder |
Nov 7 2020, 08:20 PM
Post
#2
|
Advanced Member Group: Members Posts: 4,418 Joined: 6-September 11 From: Dallas Texas Member No.: 13,524 Region Association: Southwest Region |
I took my floor jack and applied pressure to them from the bottom.
Tighten right up. |
Lo-Fi Version | Time is now: 12th June 2024 - 01:26 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |