Motor going back into car TODAY, well, sort of, have a few questions Options

[jandro62]

After 2 years of sitting in the driveway, my motor is finally going back into the 914 this afternoon! (just in time for the Texas cold front of course...) But I have a few questions. Basically, I'm following the pelican parts tech article in reverse to put it back in. The issue is lining the bolts on the transmission mounts up. Since those suckers are angled so sharply, do I need to remove the mounts entirely, or is there some trick to shimmying the trans up those bolts?

[jwalters]

OK--you seee this right here--this is good--turn that over there a few times---now lift up on that,,whooo-too much lift, let it down a little--thats good--now tighten that over there---screw this in a little--thats good--now hook that up................you got a six foot crow bar???? oh well, use that over there instead---ok, now connect this--good--ok your done!!!!

Wait a minute--whats this??? ohhh crap--ok, now take it all back apart and put this............................

(IMG:http://www.914world.com/bbs2/html/emoticons/lol2.gif) (IMG:http://www.914world.com/bbs2/html/emoticons/lol2.gif)

Just kiidin---leave everything a little loose--and then starting from the front mounts back tighten everything up----it will fit..good luck..J