 P/N on rear axles ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Literati914 |
 Mar 27 2021, 09:49 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,009 Joined: 16-November 06 From: Dallas, TX Member No.: 7,222 Region Association: Southwest Region  |
I have a set of 28 spline, 108mm shafts that were definitely running on a 914 before I got them (I only assume a 901 was being used, but never saw the transaxle). They came with a set of stock 5-lug rear hubs - as well as a set of trailing arm that had been modified to use a 911 E-brake set up (driver's side only).
I thought 108mm 911 axles wouldn't work with a stock 914 transaxle though - is that right? I'd like to find the part #s on these but they are super cruddy and I'm no-where near needing to rebuild & use them. The p/n's are not obvious, I figured they're probably under one of the CV boots - can someone confirm which (end/boot) I need to cut off to find it? TIA. . |
   |
 
|
Posts in this topic
Mark Henry I have 108mm running gear and I use Swayaway axles... Mar 28 2021, 04:31 AM Literati914 I'd like to use the axles I already have (I ju... Mar 28 2021, 10:11 AM
Mark Henry
I'd like to use the axles I already have (I j... Mar 28 2021, 10:48 AM Literati914 I laid the complete 911/108mm set up next to a set... Mar 28 2021, 06:44 PM Mark Henry
I laid the complete 911/108mm set up next to a se... Mar 29 2021, 08:35 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th July 2025 - 03:31 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.