 Headlight alignment, Getting ready to put in H4's |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ewdysar |
 Dec 28 2004, 03:47 PM
Post
#1
|
|
What happens here, stays here.  Group: Members Posts: 558 Joined: 29-October 04 From: Altadena, CA Member No.: 3,030  |
So I looked in the Haynes manual and under headlight alignment, they suggest going to a professional. I'm surprised that this job couldn't/shouldn't be done by me. (IMG:http://www.914world.com/bbs2/html/emoticons/bs.gif)
I remember aligning other car's lights in the past with specs from manuals, park car on level space xx feet from vertical wall. Draw horizontal line xx inches from ground and mark centerline of car on wall. Align each light independantly. (IMG:http://www.914world.com/bbs2/html/emoticons/rolleyes.gif) Is there something that I'm missing here? Is there something that makes this too complicated for the likes of me? Who knew that twisting a couple of screws would prove to be more difficult than swapping the suspension, installing a V8, radiator etc. etc. (IMG:http://www.914world.com/bbs2/html/emoticons/confused24.gif) Eric |
   |
 
|
  |
Replies
| ewdysar |
Dec 28 2004, 07:48 PM
Post
#2
|
|
What happens here, stays here. Group: Members Posts: 558 Joined: 29-October 04 From: Altadena, CA Member No.: 3,030 |
So I guess I'll measure to the center of the headlights and adjust the left side of the highbeam pattern to that level at about 20 feet. Then drive around and see if that's too close. I'll try to remember to post my results when I get them dialed in.
Now as soon as my dimmer relay shows up, so the high beams will stay on (IMG:http://www.914world.com/bbs2/html/emoticons/smash.gif) Thx guys... (IMG:http://www.914world.com/bbs2/html/emoticons/wavey.gif) |
|
|
|
Posts in this topic
ewdysar Headlight alignment Dec 28 2004, 03:47 PM
vsg914 Eric, remove the plastic headlight surrounds, and ... Dec 28 2004, 05:49 PM Mueller ...more than likely they just didn't want to d... Dec 28 2004, 06:06 PM Jamie My 73 has 2 alignment holes in the plastic surroun... Dec 28 2004, 07:35 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 05:34 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.