 Best Cam for 2056 and Dub Shop EFI? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bkrantz |
 Jul 14 2021, 08:11 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 8,422 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains 
 |
Since I had to tear down my partially built engine (to have the case decked), I have a second chance to choose a cam shaft. This build will be a 2056, target compression ratio of about 8.6:1, and the complete EFI and electronic ignition from the Dub Shop (based on Megasquirt 2).
Any wise suggestions? |
   |
 
|
  |
Replies
| barefoot |
Jul 15 2021, 11:23 AM
Post
#2
|
|
Senior Member Group: Members Posts: 1,409 Joined: 19-March 13 From: Charleston SC Member No.: 15,673 Region Association: South East States
|
I'm using WEB #494 cam & tappets with carbed 2056 at about 8.6 CR. Good low-mid range torque I usually ignore 1st gear unless an up-hill start. I'm happy with it
|
|
|
|
Posts in this topic
bkrantz Best Cam for 2056 and Dub Shop EFI? Jul 14 2021, 08:11 PM
EdwardBlume 9590 Raby / LN Engineering- $$$... Jul 14 2021, 10:59 PM euro911 I ran a Raby 9580 with 9.5:1 C/R and IDF-40 carbs ... Jul 15 2021, 01:07 AM BeatNavy The cam the type 4 store currently markets for bei... Jul 15 2021, 03:48 AM
ClayPerrine
The cam the type 4 store currently markets for be... Jul 15 2021, 07:49 AM 914Sixer Elgin 330-1 might work. Click to open Jul 15 2021, 06:00 AM colingreene Did you ask the dub shop?
Id go for 9.0 compressi... Jul 15 2021, 07:48 PM bkrantz Thanks, everyone. I have twin IDF throttle bodies... Jul 15 2021, 10:15 PM djway The T4 in my notchback 78x96 9.0to1 has the Webcam... Jul 15 2021, 11:28 PM JamesM The nice thing about Megasquirt is one way or anot... Jul 16 2021, 08:53 AM bkrantz At the risk of blowing this discussion wide open, ... Jul 16 2021, 07:53 PM djway
At the risk of blowing this discussion wide open,... Jul 16 2021, 08:14 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 12:33 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.