 Subaru advice, Continuous Improvement |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mowog4 |
 Jul 18 2021, 11:53 AM
Post
#1
|
|
Member  Group: Members Posts: 339 Joined: 2-November 15 From: Mesa AZ Member No.: 19,325 Region Association: None 
 |
I have put a couple thousand miles on my ‘75 WRX powered 914 and I am looking to address a couple of issues. I ran rubber lines from the radiator to engine under the car, think I am going to replace them with stainless tubing. Anyone else do this, looking for some pics and sizing suggestions so I don’t reinvent the wheel.
I also made a stupid mistake of using an eBay civic clutch master cylinder, which on a drive to breakfast is starting to fail. Chinese quality is not too impressive. Anyone have a source for Honda OEM bits? Thanks Ed |
   |
 
|
Posts in this topic
  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 10:15 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.