Distributors and Trigger Points (New Dizzy Installed), Troubleshooting Parts - CHT appears bad |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Distributors and Trigger Points (New Dizzy Installed), Troubleshooting Parts - CHT appears bad |
tvdinnerbythepool |
Sep 9 2021, 08:43 AM
Post
#1
|
Member Group: Members Posts: 310 Joined: 24-July 18 From: Olympia, WA Member No.: 22,336 Region Association: Pacific Northwest |
Hey all,
I am still chasing down an intermittent RICH condition when the car is fully warmed up. 1.7L D-Jet After fully warmed up with a tuned and rebuilt MPS I can come to a stop light and idle steady at 850rpms, next stop light it's bogging down to almost 200-300 and barely running. Then next light it's idling normally again. Some days I have no issues with idle at all, others I do. I've gone through all the components and troubleshot my way through everything on the PBANDERS list of "my car is running rich". I am as confident as I can be through extensive troubleshooting and testing that my ECU, AAR, MPS, CSV, Vacuum Leaks, CHT, Injectors, Fuel Pressure etc are all good. All new wiring harnesses, plugs, plug wires, cap, rotor, coil, etc. The ONLY thing I haven't worked on is the distributor. I am reading up on the possibility of the Trigger Sensor Contacts being warn and bouncing possibly shooting off extra injection pulses...could this be the cause of the intermittent problem? It doesn't have points anymore, but a petronix I believe. What do you guys think? Is there an easy test for this or do I replace the trigger contacts or the whole dizzy? Cheers! (IMG:style_emoticons/default/beerchug.gif) |
tvdinnerbythepool |
Sep 30 2021, 03:00 PM
Post
#2
|
Member Group: Members Posts: 310 Joined: 24-July 18 From: Olympia, WA Member No.: 22,336 Region Association: Pacific Northwest |
Update below
CHT: measured 49.7K Ohms at 63 degrees (OUT OF SPEC - NEW ONE IN THE MAIL) MPS: -Vacuum holds all day long at 15" -Calibrated with Wavetech to PBanders specs, very close specs to another sealed unit I have to compare to. TPS: Tested perfectly, Mild wear on the Board but not needing replacement. Cleaned and re-calibrated. Compression test: These are cold numbers, will repeat when new CHT installed with some hot numbers. #1: 145psi #2: 150psi #3: 155psi #4: 155psi Pleasantly surprised by those numbers, all within 10psi so whatever wear exists is nice and even. Will install new CHT hopefully tomorrow night if it gets here in time. Still need to check the intake plenum and possibly bypass the CSV. I am not convinced it's a vacuum issue as I have very low idle issues, not high, but will inspect. Really looking like the CHT is the culprit or the ECU. And now I have the infamous modified 13mm deep socket, Lol |
Lo-Fi Version | Time is now: 8th June 2024 - 12:50 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |