 Replacing Roll Bar Stainless Trim L/R sides, How do you replace the roll bar stainless anodized trim? The top has a phillips head screw; however, the bottom has a clip/spacer. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| roberthbollinger |
 Oct 1 2021, 04:54 PM
Post
#1
|
|
Newbie  Group: Members Posts: 3 Joined: 16-March 10 From: Nipomo, CA Member No.: 11,475 Region Association: Central California  |
I want to replace the anodized stainless roll bar trim on my 1973 914. The top has a philips head screw, however, the bottom has a clip/spacer that is no longer produced. Does the trim have adhesive to hold it in place? How can I avoid damaging the vinal sail panel and reinstall the new trim? How can I save the clip/spacer at the bottom of the trim?
Thank you, Bob Bollinger Roberthbollinger@aol.com |
   |
 
|
  |
Replies
| 914werke |
Oct 1 2021, 06:25 PM
Post
#2
|
|
"I got blisters on me fingers" Group: Members Posts: 11,606 Joined: 22-March 03 From: USofA Member No.: 453 Region Association: Pacific Northwest 
|
was puzzled by the title as what is described as stainless is actually anodized alum.
|
|
|
|
Posts in this topic
roberthbollinger Replacing Roll Bar Stainless Trim L/R sides Oct 1 2021, 04:54 PM
rhodyguy The nut for the clip/spacer is located in the top ... Oct 1 2021, 04:59 PM
bkrantz
The nut for the clip/spacer is located in the top... Oct 1 2021, 07:28 PM iankarr
I want to replace the anodized stainless roll bar... Oct 1 2021, 04:59 PM windforfun
I want to replace the anodized stainless roll ba... Oct 2 2021, 11:11 AM Mikey914 Got you covered
https://914rubber.com/roll-bar-t... Oct 1 2021, 04:59 PM iankarr 914 rubber to the rescue. Didn’t realize those w... Oct 1 2021, 05:05 PM mepstein Get some good light in there and it will help. Oct 1 2021, 07:59 PM Mikey914 Our next round on these we will make the "bol... Oct 1 2021, 09:56 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 02:51 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.