 What is this part for?, Location |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| EJP914 |
 Oct 24 2021, 05:45 PM
Post
#1
|
|
Member  Group: Members Posts: 260 Joined: 14-June 03 From: Monroeville, PA Member No.: 821  |
What is this? Took this off my car (73 -1.7) months ago and cant remember from where I removed it. Looks like a cover for something??? Thx for the help.
EJP914  |
   |
 
|
  |
Replies
| wonkipop |
Oct 26 2021, 11:59 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 4,397 Joined: 6-May 20 From: north antarctica Member No.: 24,231 Region Association: NineFourteenerVille 
|
i had a look again at my engine.
yes i see the little cap up there on the back of the case at the flywheel. still got my plug there. its much smaller than the fan shroud timing plug. my timing plug which has a 4 "blade" top has long had one of the blades fractured. since i have owned it if i recall right. about 32 years. be nice to get a new one. bit hard to find something like that in aus. these sort of items would be handy for restorers. the plastic does go brittle after all this time. very fragile items now. |
|
|
|
Posts in this topic
EJP914 What is this part for? Oct 24 2021, 05:45 PM
914werke inspection plug rear engine case Oct 24 2021, 05:52 PM L-Jet914 I didn't realize there was supposed to be litt... Oct 24 2021, 11:51 PM jvmarino It would be great if 914Rubber made them. Mine br... Oct 25 2021, 09:01 AM bkrantz Porsche/VW part number 021 101 109. NLA. Oct 25 2021, 09:04 PM wonkipop part # i get from catalogue = 021 119 233A
(timing... Oct 25 2021, 09:55 PM Mikey914 Something looks a little off. The 72 I have in the... Oct 26 2021, 02:36 AM
jvmarino
Something looks a little off. The 72 I have in th... Oct 26 2021, 03:55 AM Shivers :) Oct 26 2021, 06:45 AM brant Mark. I have a clean one I could send you for tomo... Oct 26 2021, 07:15 AM ejm That hole was used to access the flex plate/torque... Oct 26 2021, 09:54 AM Mikey914 Yes I can see now. Fairly simple to produce. Drop ... Oct 27 2021, 12:24 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 08:39 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.