 Fog light removal |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Shredhead |
 Jan 28 2022, 10:30 AM
Post
#1
|
|
Member  Group: Members Posts: 113 Joined: 10-August 15 From: CT Member No.: 19,047 Region Association: North East States  |
I'd like to completely remove my fog lights, leaving just the wires, in preparation for painting and so I can clean them up on the bench. I'm not sure I see how the wires disconnect and would prefer not to cut them. Any tips?
Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| 914Sixer |
Jan 28 2022, 10:40 AM
Post
#2
|
|
914 Guru Group: Members Posts: 9,124 Joined: 17-January 05 From: San Angelo Texas Member No.: 3,457 Region Association: Southwest Region 
|
Using a little flat blade, unscrew set screw on bulb holder, be careful not to loose it. Pull out white/yellow wires (solder on ends). Slide off brown ground wire. Pull rubber plug out the housing.
|
|
|
|
| Shredhead |
Jan 28 2022, 02:09 PM
Post
#3
|
|
Member Group: Members Posts: 113 Joined: 10-August 15 From: CT Member No.: 19,047 Region Association: North East States |
QUOTE(914Sixer @ Jan 28 2022, 11:40 AM)  Using a little flat blade, unscrew set screw on bulb holder, be careful not to loose it. Pull out white/yellow wires (solder on ends). Slide off brown ground wire. Pull rubber plug out the housing. So pull the wires out of their solders, right? |
|
|
|
Posts in this topic
Shredhead Fog light removal Jan 28 2022, 10:30 AM
76-914 The tip of the + wire(s) is soldered but that sold... Jan 28 2022, 05:00 PM Shredhead
The tip of the + wire(s) is soldered but that sol... Feb 5 2022, 01:22 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 02:55 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.