 how to drill holes for passenger side door mirror, passenger door mirror |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jim dorociak |
 Feb 6 2022, 06:45 PM
Post
#1
|
|
Member  Group: Members Posts: 97 Joined: 23-January 09 From: Newbury Park, Ca Member No.: 9,966 Region Association: Southern California 
 |
guys I can see from inside the door where the holes go, but am looking for the proper way to drill down from the topside and get these holes right the first time.
Anybody have any ideas? Thanks! Jim |
   |
 
|
  |
Replies
| Cairo94507 |
Feb 7 2022, 10:51 AM
Post
#2
|
|
Michael Group: Members Posts: 10,319 Joined: 1-November 08 From: Auburn, CA Member No.: 9,712 Region Association: Northern California
|
I would suggest applying some tape to the exterior painted area where the mirror goes to protect the paint while you are drilling. Then remember to touch up the bare metal hole edges with some paint before you install the mirror.
|
|
|
|
Posts in this topic
jim dorociak how to drill holes for passenger side door mirror Feb 6 2022, 06:45 PM
davep Use a center point tool with hammer to create a li... Feb 6 2022, 06:50 PM
windforfun
Use a center point tool with hammer to create a l... Feb 6 2022, 07:19 PM mepstein If you want to go from the outside in, the dimensi... Feb 6 2022, 07:07 PM Front yard mechanic
If you want to go from the outside in, the dimens... Feb 7 2022, 08:40 AM jim dorociak when you guys are talking about center punch going... Feb 6 2022, 07:35 PM Shivers
when you guys are talking about center punch goin... Feb 6 2022, 07:56 PM jim dorociak Thank you to all who replied. I will report back w... Feb 6 2022, 08:55 PM vitamin914 Here is a how to article from Pelican Parts.
http... Feb 7 2022, 06:29 AM bkrantz Rather than drill "fulll size" and risk ... Feb 7 2022, 08:58 PM ClayPerrine I just recently did this on the factory six. I ha... Feb 8 2022, 09:48 AM jim dorociak Thanks everyone for the options on how to do this.... Feb 8 2022, 12:25 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 05:30 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.