 3.2 with 914 transmission: sensor locations, Where do I cut the housing? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mitox |
 May 18 2022, 07:22 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 530 Joined: 26-October 15 From: SW Virginia Member No.: 19,302 Region Association: South East States 
 |
I’ve disassembled my 914 trans, so I can clean and paint the case prior to a rebuild. It will be hooked up to a 3.2 retaining the fuel injection and Motronics. Before it is painted I’d like to cut the notches needed in the case for the Motronic sensors, but I don’t have a clue where to cut.
Can anyone point me in the right direction, or better yet, have measurements or a template for the cuts. Thanks for any help you may have |
   |
 
|
Posts in this topic
mepstein :driving: May 18 2022, 08:07 PM SirAndy Not the best pictures but i don't remember thi... May 18 2022, 08:28 PM Steve All I did was slide the 914 gear box onto the 3.2 ... May 18 2022, 09:05 PM
mepstein
All I did was slide the 914 gear box onto the 3.2... May 18 2022, 09:56 PM Mitox Thanks for the direction everyone. I’ll mount t... May 20 2022, 03:28 PM worn
Thanks for the direction everyone. I’ll mount ... May 20 2022, 05:21 PM Tdskip Same here - passenger side near top. May 20 2022, 06:44 PM Maltese Falcon In the days of 3.2 Vanagon conversions, I used to ... May 20 2022, 07:37 PM Mitox
In the days of 3.2 Vanagon conversions, I used to... May 20 2022, 08:20 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th March 2026 - 12:21 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.