 Question on “A” 3.5 caliper rebuild |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| brant |
 Dec 8 2022, 06:07 PM
Post
#1
|
|
914 Wizard  Group: Members Posts: 11,949 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains 
 |
Any one know which way to orient the caliper piston on 911 A calipers?
My right and left sides are 90 degrees different from each other I’m doing a maintenance rebuild and I assumed I could put the pistons back as before until I found the RF to be different than LF Picture of the cut edge: Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| Eric_Shea |
Dec 8 2022, 07:06 PM
Post
#2
|
|
PMB Performance Group: Admin Posts: 19,304 Joined: 3-September 03 From: Salt Lake City, UT Member No.: 1,110 Region Association: Rocky Mountains |
The 20° Notch will face upward toward the bleeder on each one. I don’t have the graphic on my phone right now. I’ll load it when I get to a PC
|
|
|
|
| brant |
Dec 8 2022, 07:11 PM
Post
#3
|
|
914 Wizard Group: Members Posts: 11,949 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains
|
QUOTE(Eric_Shea @ Dec 8 2022, 06:06 PM)  The 20° Notch will face upward toward the bleeder on each one. I don’t have the graphic on my phone right now. I’ll load it when I get to a PC Thank you sir! Not urgent Hey.. maybe steamboat next September Nice drive through dinosaur! |
|
|
|
Posts in this topic
brant Question on “A” 3.5 caliper rebuild Dec 8 2022, 06:07 PM
Eric_Shea
The 20° Notch will face upward toward the bleed... Dec 8 2022, 07:43 PM
brant Correct
20mm vented
Is it a PDF or template? I ... Dec 9 2022, 10:00 AM Eric_Shea
Correct
20mm vented
Is it a PDF or template? I... Dec 9 2022, 11:41 AM PatMc Here you go Dec 9 2022, 11:10 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 07:10 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.