Any one know which way to orient the caliper piston on 911 A calipers?
My right and left sides are 90 degrees different from each other
I’m doing a maintenance rebuild and I assumed I could put the pistons back as before until I found the RF to be different than LF
Picture of the cut edge:
Full Version: Question on “A” 3.5 caliper rebuild
The 20° Notch will face upward toward the bleeder on each one. I don’t have the graphic on my phone right now. I’ll load it when I get to a PC
QUOTE(Eric_Shea @ Dec 8 2022, 06:06 PM) 
The 20° Notch will face upward toward the bleeder on each one. I don’t have the graphic on my phone right now. I’ll load it when I get to a PC
Thank you sir!
Not urgent
Hey.. maybe steamboat next September
Nice drive through dinosaur!
QUOTE(brant @ Dec 8 2022, 06:11 PM)
QUOTE(Eric_Shea @ Dec 8 2022, 06:06 PM)
The 20° Notch will face upward toward the bleeder on each one. I don’t have the graphic on my phone right now. I’ll load it when I get to a PC
Thank you sir!
Not urgent
Hey.. maybe steamboat next September
Nice drive through dinosaur!
I’ll send you a pair tomorrow. 20mm vented rotors correct?
Steamboat sounds great.
Correct
20mm vented
Is it a PDF or template? I assume
20mm vented
Is it a PDF or template? I assume
Here you go
QUOTE(brant @ Dec 9 2022, 09:00 AM)
Correct
20mm vented
Is it a PDF or template? I assume
Leave them. I have a set coming your way. Late RRC prize winner
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.