![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
nivekdodge |
![]()
Post
#1
|
Member ![]() ![]() Group: Members Posts: 251 Joined: 28-August 21 From: Pittsburgh Pa Member No.: 25,860 Region Association: MidAtlantic Region ![]() ![]() |
Like Bob Krantz, Powerplant in ....Powerplant out.Cha-Cha. I'm waiting for tranny parts and replaced the one pushrod seal that was leaking. The motor still has oil in it. Can i tilt it 10 degrees or so overnight to check for a leak?
Kevin |
![]() ![]() |
r_towle |
![]()
Post
#2
|
Custom Member ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 24,594 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States ![]() ![]() |
You do not need to remove the tube from the engine to simply replace the seal. If you must remove the whole tube for replacement, you sadly will need to drop the engine.
Otherwise, remove rockers, pull tube and pushrod out far enough to replace seal, then install again. Rich |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 17th June 2024 - 09:02 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |