Cell phone / Smartphone mount V2 - ON STOCK, Accepting order : Please contact by mail Options

[johannes]

AVAILABLE ACCEPTING ORDERS

I made an improved design that is better looking, doesn't need any assembly and no painting. It's shipped ready to use and features a "from the shelf" claw that makes the design much better than my previous one.

It's still 3D printed with high strength Polyamid (SLS) and the finish is satin black. This printing technique makes very fine detail and smooth surface possible.

The mount will lock in the ashtray support and doesnt need any screw.
You can install and remove it without any tool and it is locked in place tightly. I tested it for one year and it works very well.
You can put the excess power cable in the tray if needed (see picture)
Will fit phones from 2.55 to 3.35 inches, (65 to 85mm)

Price included worldwide shipping is 45 Euros - Order by PM

This item is made for the community. A lot of effort was put in designing this mount and it is sold at production cost.


AVAILABLE ACCEPTING ORDERS CONTACT ME AT johannes914 (at) gmail.com


Best regards

JOhannes (France)

[infraredcalvin]

@johannes

Would you please confirm the size of the ball the claw attaches to? I’m looking to use it with other accessories and am looking for a 1 inch (25.4mm ) ball.

Thank you, looks promising!

[arbitrary]

@johannes

Would you please confirm the size of the ball the claw attaches to? I’m looking to use it with other accessories and am looking for a 9/16 inch (25.4mm ) ball.

Thank you, looks promising!

I’m guessing you mean 14.5mm?