 CV Joint Boot Clamp, What have you tried |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DennisV |
  Jul 11 2023, 07:36 AM
Post
#1
|
|
Member  Group: Members Posts: 479 Joined: 8-August 20 From: Santa Rosa, CA Member No.: 24,575 Region Association: Northern California 
 |
Original style 914-6 terminal (aka dust bellows boot clamp) 914-332-335-00 for CV joints appear to be NLA. I assume I can reuse my protection caps and add new dust bellows. That leaves the clamp. I'll try to reuse my existing clamps, but if that fails does anyone have experience with:
I'm honestly not sure how you secure the Porsche one. |
   |
 
|
  |
Replies
| Root_Werks |
Aug 7 2023, 05:10 PM
Post
#2
|
|
Village Idiot Group: Members Posts: 8,331 Joined: 25-May 04 From: About 5NM from Canada Member No.: 2,105 Region Association: Pacific Northwest
|
I've had good luck with SS Zip Ties for use on things that aren't under much or any pressure:
https://www.acehardware.com/departments/lig...mp;gclsrc=aw.ds You can even buy a little hand tool that will pull them tight. Low profile, clean looking, never failed me yet. Used them on T1 Swing Axel Boots and other CV boots. |
 |
|
Posts in this topic
DennisV CV Joint Boot Clamp Jul 11 2023, 07:36 AM
914Sixer All the CV boots now have the rubber boot crimped ... Jul 11 2023, 07:39 AM technicalninja He's talking about the boot clamp where is fit... Jul 11 2023, 08:54 AM
DennisV
All the CV boots now have the rubber boot crimped... Jul 11 2023, 04:37 PM Geezer914 I used a small plastic wire tie. Jul 11 2023, 10:09 AM Krieger I don't using anything on my 6. There has nev... Jul 11 2023, 11:20 AM MasterCylinder Look for oetiker clamps.
Last ones I purchased I... Jul 11 2023, 06:36 PM mate914 This it the best advise you got so far. The oetike... Jul 11 2023, 06:55 PM Van B
Look for oetiker clamps.
Last ones I purchased ... Aug 7 2023, 04:59 PM Literati914
This it the best advise you got so far. The oetik... Jul 11 2023, 09:39 PM mate914 Pex used in hydronic heating is pressure tested at... Jul 12 2023, 04:52 AM rhodyguy SS screw clamps found in the plumbing department. ... Jul 11 2023, 09:52 PM DennisV For anyone following along, some more datapoints:
... Aug 7 2023, 04:52 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 08:53 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.