Oil Leaks, I am tired of them Options

[sdoolin]

Rebuilt my 2.0 back in 2016. Full "Raby Spec" 2056. Runs very well. It is out of the car right now as I am dealing with a rusty battery tray (separate thread on that). It appears that I have leaks at most/all of the pushrod tube seals, the valve cover seals, and the rear main seal. This is not a surprise to me, I clean the bottom of the engine regularly, and knew this day was coming

Pretty sure I used the Victor Reinz gasket set that came with my engine "kit" from the Type IV Store. I used the cork valve cover seals from the Victor Reinz set. I did not use any RTV anywhere. Hate the stuff. I know I used a rear main seal from GoWesty as someone back then had suggested it is a better part then what is included with the Victor Reinz set.

I installed new pushrod tubes and used the O-Rings from the Victor Reinz set.

Does anyone really have an oil tight VW Type IV engine? If yes, how does none do that?

[Literati914]

..Just looked closer at the above pushrod tubes. Those are for a type I VW, not a 914 head.

OK and there's multiple options for these on a VW 1600 apparently - so strange if nobody offered the same for a type 4.. I didn't take much time looking into it but I wonder if there are any options via the aircraft industry. If not, then here's a business opportunity for some industrious types.

.

[ClayPerrine]

..Just looked closer at the above pushrod tubes. Those are for a type I VW, not a 914 head.

OK and there's multiple options for these on a VW 1600 apparently - so strange if nobody offered the same for a type 4.. I didn't take much time looking into it but I wonder if there are any options via the aircraft industry. If not, then here's a business opportunity for some industrious types.

.

I have a set of those fancy valve covers for a Type IV. Not worth the money. They don't prevent leaks any better than the stock covers, and the rubber gaskets are hard to find.

If I can find all the hardware for them, you can have them for free.