Oil Leaks, I am tired of them Options

[sdoolin]

Rebuilt my 2.0 back in 2016. Full "Raby Spec" 2056. Runs very well. It is out of the car right now as I am dealing with a rusty battery tray (separate thread on that). It appears that I have leaks at most/all of the pushrod tube seals, the valve cover seals, and the rear main seal. This is not a surprise to me, I clean the bottom of the engine regularly, and knew this day was coming

Pretty sure I used the Victor Reinz gasket set that came with my engine "kit" from the Type IV Store. I used the cork valve cover seals from the Victor Reinz set. I did not use any RTV anywhere. Hate the stuff. I know I used a rear main seal from GoWesty as someone back then had suggested it is a better part then what is included with the Victor Reinz set.

I installed new pushrod tubes and used the O-Rings from the Victor Reinz set.

Does anyone really have an oil tight VW Type IV engine? If yes, how does none do that?

[Jack Standz]

Available for approximately $20 to $25 from your favorite vendors:

https://www.autohausaz.com/pn/UN1201100

BTW a stock valve cover does work well if it's not too banged-up. But, if you have non-stock rocker arms/adjusters, the cast one from CB Performance clears rockers that won't fit in a stock valve cover and with the silicone rubber gaskets, they don't leak.

[ericoneal]

I'm up the road from you in Crestwood and have one of these if you want to borrow it.

Available for approximately $20 to $25 from your favorite vendors:

https://www.autohausaz.com/pn/UN1201100

BTW a stock valve cover does work well if it's not too banged-up. But, if you have non-stock rocker arms/adjusters, the cast one from CB Performance clears rockers that won't fit in a stock valve cover and with the silicone rubber gaskets, they don't leak.