 Shift rod balls, How do I get those installed |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| PaIsa |
 Jan 11 2025, 03:22 PM
Post
#1
|
|
Member  Group: Members Posts: 129 Joined: 13-June 24 From: Quebec, Canada Member No.: 28,180 Region Association: Canada  |
I got most of the material I ordered so I started to install some of the goodies.
We tried to get the shift rod balls on the shift rod just after the fire wall, without any success. I know someone said to heat them. I tried using boiling water, no success. I will try with heating the ball and freezing the steel part. Any other suggestion. These balls are hard and tricky to get aligned straight. Again open for any advice. Thanks |
   |
 
|
  |
Replies
| rhodyguy |
Feb 1 2025, 05:34 PM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,249 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
Use vise grips and a shop rag to securely hold the ball and not mar it.
|
 |
|
Posts in this topic
PaIsa Shift rod balls Jan 11 2025, 03:22 PM
r_towle Post a pic
I have not needed to use heat or coldâ€... Jan 11 2025, 08:55 PM bdstone914 Not clear as to what you are asking. Is this a ta... Jan 11 2025, 09:29 PM
PaIsa
Not clear as to what you are asking. Is this a t... Jan 13 2025, 10:05 AM r_towle Maybe it’s a tail shifter?
The cup bushings pop ... Jan 11 2025, 10:14 PM Front yard mechanic
Maybe it’s a tail shifter?
The cup bushings pop... Feb 1 2025, 07:31 PM mepstein Light grease and tap it on with a plastic mallet. ... Jan 13 2025, 11:02 AM PaIsa
Light grease and tap it on with a plastic mallet.... Jan 17 2025, 07:52 AM ChrisFoley Do them at room temperature.
I use a one ton arbor... Jan 17 2025, 11:23 AM Shivers Not sure if you saw this thread. Lots of good info... Jan 17 2025, 12:35 PM JamesM They take a bit of foundling!
Sorry I couldn... Jan 17 2025, 06:37 PM PaIsa I finally got one installed using some grease and ... Feb 1 2025, 04:46 PM worn
I finally got one installed using some grease and... Feb 1 2025, 06:22 PM PaIsa
I finally got one installed using some grease an... Feb 1 2025, 07:36 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 12:43 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.