Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Clutch & throttle cable questions
DC_neun_vierzehn
post Nov 2 2026, 08:28 AM
Post #1


Senior Member
***

Group: Members
Posts: 696
Joined: 16-November 20
From: Coastal Delaware
Member No.: 24,893
Region Association: MidAtlantic Region



Last night, I think my throttle cable snapped. I believe it snapped somewhere in the tunnel (bc it's still attached at both ends). Bummer bc I just put it on about 6 months ago. I thought I avoided wrapping it around the clutch cable, but I must not have.

Thus, I thought I would replace both cables "while I'm in there" this time (in case the wrapping/rubbing did any damage to the clutch cable). I thought I read in a post recently that if installing both cables, install the throttle cable first, then the clutch calbe, to help avoid the wrapping issue.

Is that the correct order?

I have a bore scope that I will use and will obviously be more careful this time. Any other helpful tips are welcomed.
User is online!Profile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
DC_neun_vierzehn
post Nov 4 2026, 01:05 PM
Post #2


Senior Member
***

Group: Members
Posts: 696
Joined: 16-November 20
From: Coastal Delaware
Member No.: 24,893
Region Association: MidAtlantic Region



Well I dug into the job last night.

Good news: I don’t have to replace my cables).

After removing pedal board I discovered that the threaded ball socket attachment at the end of the throttle cable had simply popped off of the ball where it connects to the pedal assembly.

Before popping it back on, I looked into the tunnel with a scope and noticed the throttle cable was wrapped around the clutch cable. I got that addressed and then reattached the ball socket.

So here’s my question: would the wrapping cause the ball socket to pop off (6 months after installing the throttle cable)?

Or can the metal on the ball socket open up a little after 50 years, and lead to a loose fit that’s prone to popping off? Has anybody had this problem?
User is online!Profile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 22nd November 2026 - 05:18 PM
...