 remote start button, wiring help |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| machina |
 Mar 2 2005, 01:09 PM
Post
#1
|
|
Advanced Member  Group: Benefactors Posts: 2,030 Joined: 21-June 03 From: Miami Beach, FL Member No.: 848   |
I want a remote start button in the engine bay. Do I just attach the 2 wires from the button to the the big pole and ignition tab on the starter directly?
|
   |
 
|
  |
Replies
| Brando |
Mar 2 2005, 08:19 PM
Post
#2
|
|
BUY MY SPARE KIDNEY!!! Group: Members Posts: 3,935 Joined: 29-August 04 From: Santa Ana, CA Member No.: 2,648 Region Association: Southern California |
From the solenoid to the big + pole works perfectly fine.
I'd just eliminate the button/switch and leave the wire there. Wrap it up somewhere. putting it through a switch adds one more thing to fault-check when you could just tap the wire to the battery... |
|
|
|
Posts in this topic
synthesisdv remote start button Mar 2 2005, 01:09 PM
john rogers I wired mine from the kill switch outlet to the st... Mar 2 2005, 01:12 PM Rand What you suggested will work. Big pole (12v) to so... Mar 2 2005, 02:20 PM synthesisdv Is there a liabiltiy to doing this?
One thing I t... Mar 2 2005, 02:32 PM Rand Make sure the connections are clean and protected ... Mar 2 2005, 02:48 PM Flat VW Have your wife start the car, that's what the ... Mar 2 2005, 05:19 PM bd1308 i was going to say mount it in the rear trunk but ... Mar 2 2005, 05:28 PM redshift Just use clips, and remove it when you are not wor... Mar 2 2005, 05:29 PM bd1308 <... Mar 2 2005, 05:33 PM redshift And subject to the elves of hell when you least ex... Mar 2 2005, 05:39 PM scruz914 Mar 2 2005, 08:40 PM Flat VW Arcing around a battery can be a problem in some c... Mar 2 2005, 08:46 PM scruz914 Mar 2 2005, 09:06 PM Type 4 Here is a Marine switch that will work
http://www.... Mar 2 2005, 10:12 PM scott thacher you can take a spade terminal from the connector a... Mar 2 2005, 10:47 PM Bruce Allert I found a nice horn button about an inch in diamet... Mar 2 2005, 11:11 PM
Racer Chris I have a 12v momentary switch attached to about 4 ... Mar 3 2005, 01:01 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 12:42 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.