 removing the old a-arm bushings, map torch? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rhodyguy |
 Mar 9 2005, 12:19 AM
Post
#1
|
|
Chimp Sanctuary NW. Check it out.  Group: Members Posts: 22,252 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch  |
just burn them out? any other tricks? will one bottle be enough? al blose hooked me up with a nice pair that i'm going to elephantise. thanks al.
k |
   |
 
|
  |
Replies
| skline |
Mar 9 2005, 12:26 AM
Post
#2
|
|
Born to Drive Group: Members Posts: 7,910 Joined: 26-December 02 From: Costa Mesa, CA Member No.: 17 Region Association: Southern California |
I have always heard burn them out. I have to remove my rear bushins soon to install the roller bearings and the ones I installed before were the urethane weltmiester. They went in tight so I know they will be a bear to get out. Let me know how you do it and how it went.
|
|
|
|
Posts in this topic
rhodyguy removing the old a-arm bushings Mar 9 2005, 12:19 AM
Aaron Cox uh... i used channel locks to pull the bushings ou... Mar 9 2005, 12:50 AM fiid I used mapp gas, an hammer and the interior tube (... Mar 9 2005, 12:55 AM SpecialK If I recall correctly (big "if"), I stuck my A-ar... Mar 9 2005, 04:31 AM ablose58 Hey Kev, burn baby burn, h... Mar 9 2005, 05:52 AM Racer Chris Put the end bracket in a vise and heat it (the met... Mar 9 2005, 05:59 AM Gint The last set I did, the fronts burned out easily. ... Mar 9 2005, 07:50 AM Eric_Shea Heat until you see a whisp of smoke. I never unde... Mar 9 2005, 09:23 AM rhodyguy you had me going with the "rears" for a momment er... Mar 9 2005, 09:41 AM Eric_Shea Oh yeah... well you had me going yesterday http://www.914world.com/b... Mar 9 2005, 12:34 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th December 2025 - 12:47 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.