 Cam tolerance - side to side on the 6, Anybody know??? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mike D. |
  Mar 16 2005, 12:12 AM
Post
#1
|
|
OK, It runs now, and pretty good too!  Group: Members Posts: 1,445 Joined: 3-January 03 From: Santa Clarita, Ca Member No.: 85 Region Association: None 
 |
I'm timing the cams on a 2.0E engine and from one side to the other the difference is consistantly .005". the lift is correct but the left always seems to come higher or lower as the case may be. The difference is greater when I slip the cam back and put the pin in the next hole.
Anybody know what the acceptable slop would be here? TIA, Mike D. |
   |
 
|
  |
Replies
| ArtechnikA |
Mar 16 2005, 07:00 AM
Post
#2
|
||
|
rich herzog Group: Members Posts: 7,390 Joined: 4-April 03 From: Salted Roads, PA Member No.: 513 Region Association: None |
you go to the closest hole; that's the tolerance. these engines are not really ultra-sensitive to cam timing... |
||
|
|
|
||
Posts in this topic
Mike D. Cam tolerance - side to side on the 6 Mar 16 2005, 12:12 AM
sixnotfour If youre talking about the tolerance at overlap f... Mar 16 2005, 12:27 AM
Thorshammer .005 is .127mm this is very small, this is accepta... Mar 16 2005, 09:46 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 04:17 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.