 Not too bad a job, First time panel replacement |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| skline |
 Mar 23 2005, 05:55 PM
Post
#1
|
|
Born to Drive  Group: Members Posts: 7,910 Joined: 26-December 02 From: Costa Mesa, CA Member No.: 17 Region Association: Southern California  |
Well, despite what everyone said I cut out the badly damaged panel and welded in a new piece. I had the piece laying around and it seemed the right thing to use it for. Here are the results. Not too bad for my first time. Here is the spot cut out.
Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| Verruckt |
Mar 24 2005, 12:26 AM
Post
#2
|
||
|
Senior Member Group: Members Posts: 716 Joined: 14-July 04 From: Midwest Member No.: 2,348 |
Yeah you should be fine. But just to be safe... when you are all done working, be sure and scrub that area with thinner to get it good and clean. (IMG:http://www.914world.com/bbs2/html/emoticons/wink.gif) |
||
|
|
|
||
Posts in this topic
skline Not too bad a job Mar 23 2005, 05:55 PM
skline Here is the panel welded in. One low spot on the v... Mar 23 2005, 05:56 PM skline From the rear looking forward. Mar 23 2005, 05:57 PM skline The part I was worried wouldnt come out right. Ver... Mar 23 2005, 05:57 PM rick 918-S Looks good Scott. Now hold a piece of copper or Br... Mar 23 2005, 06:04 PM skline <... Mar 23 2005, 06:19 PM skline I guess I did ok, I got very little warpage. The o... Mar 23 2005, 06:24 PM spunone Scott let me know if ya need some copper or brass ... Mar 23 2005, 06:34 PM skline Thanks for the offer, I got it handled. All the ho... Mar 23 2005, 07:41 PM watsonrx13 <... Mar 23 2005, 07:52 PM skline I had a piece about 2x8 that I clamped to the meta... Mar 23 2005, 07:56 PM skline Ouch!!! There is nothing like the feel... Mar 23 2005, 11:05 PM McMark Nice job Scott! Looks great! Mar 23 2005, 11:26 PM skline I didnt put anything on it yet, I have too much to... Mar 23 2005, 11:28 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 09:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.