 Any six cylinder guys have an answer to this?, Need to remove the blob from this shaft |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Thorshammer |
 Mar 24 2005, 11:16 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 749 Joined: 11-November 03 Member No.: 1,335  |
So heres the deal.
This alternator shaft weighs a ton and I don't need no stinking amps, so I gutted the housing, now I want to gut this thing. I have tried turning on my lathe, but the casing seems really hard. maybe heat treated over the years??? Any suggestions, someone make a shaft to eliminate this piece, probably do I'm just too stupid to know, it's killing me, HELP!!!!! Motor must go in on saturday. Erik Attached image(s) 
|
   |
 
|
  |
Replies
| Thorshammer |
Mar 26 2005, 09:31 PM
Post
#2
|
|
Senior Member Group: Members Posts: 749 Joined: 11-November 03 Member No.: 1,335 |
I tried to press the shaft off of the rotor, made tool and everything. I had 35 ton on it and it went no where. So I cut the fingers off and turned the exterior down on the lathe. Just needed some carbide cutters. Did'nt have any. This would be something nice to make. I may spin up a couple of these. May not need a key way since the load is limited.
Erik |
|
|
|
Posts in this topic
Thorshammer Any six cylinder guys have an answer to this? Mar 24 2005, 11:16 PM
J P Stein Humm....you have a lathe?......Make a new shaft. T... Mar 25 2005, 02:50 AM gaz914 The "thing" is called a rotor.
Apart from the elec... Mar 25 2005, 03:34 AM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 11:11 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.