Engine Install Today (hopefully), Last minute questions |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Engine Install Today (hopefully), Last minute questions |
Allan |
Mar 27 2005, 08:05 AM
Post
#1
|
Teenerless Weenie Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California |
Going to try and put my motor back in the car today and have a few last minute questions.
1) Tranny to motor fasteners, is there a torque spec? 2) CV joint gaskets, go in dry? 3) Exhaust stud nuts, copper or steel? I will probably post a few more as things progress during the process. Thanks |
skline |
Mar 27 2005, 08:52 AM
Post
#2
|
||
Born to Drive Group: Members Posts: 7,910 Joined: 26-December 02 From: Costa Mesa, CA Member No.: 17 Region Association: Southern California |
The transmission to engine, There may be a torque spec but I just put them in till they are really tight, I have never used a spec. CV joint gaskets, make sure you grease the CV's up really good with new grease and then the gaskets should be new and dry. I use the copper ones because they are 12mm and you can get a socket on them easily. If you use anything else, you may not. Besides, they are better and designed for that. |
||
Lo-Fi Version | Time is now: 9th June 2024 - 05:53 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |