 #746 is on jackstands, not for long |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Trekkor |
 Apr 18 2005, 02:53 PM
Post
#1
|
|
I do things...  Group: Members Posts: 7,809 Joined: 2-December 03 From: Napa, Ca Member No.: 1,413 Region Association: Northern California  |
I did a brake inspection, changed out the rear springs, pulled the distributor for a part # and am replacing one of the oil lines above the chain cover.
What year and car is this dizzy from? I'm going to order a Pertronix module. KT Attached image(s) 
|
   |
 
|
  |
Replies
| ArtechnikA |
Apr 18 2005, 03:12 PM
Post
#2
|
||
|
rich herzog Group: Members Posts: 7,390 Joined: 4-April 03 From: Salted Roads, PA Member No.: 513 Region Association: None |
is there a Porsche part number on that thing anywhere? 9x1.602.nnn.nn i don't have a cross-reference of Bosch numbers to Porsche numbers. Cap'n Krusty might... |
||
|
|
|
||
Posts in this topic
trekkor #746 is on jackstands Apr 18 2005, 02:53 PM
trekkor up... Apr 18 2005, 02:57 PM trekkor Here's a good shot of the SRP front bar set-up Apr 18 2005, 03:00 PM trekkor 200# rear schprings... http://... Apr 18 2005, 03:02 PM trekkor I'll get the oil line repaired today and put i... Apr 18 2005, 03:10 PM smg914 Bosch type 0 231 159 001 were used in the early 91... Apr 18 2005, 03:31 PM trekkor When you say "early" do you mean 65-67?
Other #... Apr 18 2005, 03:43 PM ArtechnikA <... Apr 18 2005, 04:13 PM trekkor Pertronix lists a differant part for 65-67, 68, 69... Apr 18 2005, 09:21 PM Travis Neff Hey Trekk, I just jumped from 150's to 250... Apr 18 2005, 10:37 PM trekkor I haven't put the wheels back on yet.
Looking ... Apr 18 2005, 11:11 PM nebreitling what's your setup, travis? rear bar?
n Apr 18 2005, 11:30 PM trekkor Done!
Ran the 200#'s up and down the vine... Apr 20 2005, 09:40 PM Eddie914 How did you set the timing?
Did you have to get u... Apr 20 2005, 09:49 PM trekkor I used the sight hole between the engine and trans... Apr 20 2005, 09:53 PM
Travis Neff My setup is:
22mm torsion bars
22mm sway bar (set... Apr 20 2005, 10:36 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 12:00 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.