 Source for weld in camber boxes |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| john rogers |
 Apr 19 2005, 11:19 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,525 Joined: 4-March 03 From: Chula Vista CA Member No.: 391  |
Does anyone have a source for weld in camber boxes that will work on a 914? Time to beef up the front end a tad I think.
|
   |
 
|
  |
Replies
| groot |
Apr 20 2005, 05:48 AM
Post
#2
|
|
Dis member Group: Members Posts: 896 Joined: 17-December 03 From: Michigan Member No.: 1,444 |
Hey, John.... you may not remember me, but I used to auto-x in San Diego with you (SCCA) a few years ago. My 914 was yellow then. You drove it once around the parking lot to check the shifter slop for me...
Anyway, I made my own weld-in camber plates, which wasn't too bad, but if I did it over again, I'd go with the ground control units, even though they aren't weld-in. They have a better bearing system in the upper mount. Check out this thread: Camber plate discussion |
|
|
|
Posts in this topic
john rogers Source for weld in camber boxes Apr 19 2005, 11:19 PM
Mueller SmartRacing
Tony @ TC Design has some pictures on... Apr 19 2005, 11:55 PM Mueller more pics @ monster V8 mods
http://www.tcdesignfa... Apr 19 2005, 11:58 PM Jeroen http://www.ground-control.com/ Apr 20 2005, 05:26 AM Jeroen I'm not sure if the Ground Control camberplate... Apr 20 2005, 07:26 AM john rogers Hi Kevin, I do remember, so I guess I'm not as... Apr 20 2005, 09:05 AM groot Apr 20 2005, 10:54 AM ninepfourteen AircooledRacing.com
Tell Steve Fred sent you. Apr 20 2005, 10:57 AM phantom914 Apr 20 2005, 11:05 AM Jeroen as long as there's no or little load (up down ... Apr 20 2005, 04:12 PM Thorshammer Yes,
Aircooled racing, Ask for Steve 717 432-411... Apr 22 2005, 03:04 PM slivel Mine are from The Racers Group. But as you can s... Apr 22 2005, 05:17 PM
john rogers Thanks Steve, I had seen yours once when the car w... Apr 22 2005, 07:15 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 08:58 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.