 transmission guys, you know who you are |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ws91420 |
 May 7 2005, 11:57 AM
Post
#1
|
|
Yes I have one a Lensley 914  Group: Members Posts: 2,063 Joined: 10-September 03 From: Ruther Glen,VA (halfway between sticks and civilization) Member No.: 1,137 Region Association: MidAtlantic Region  |
I'm replacing the synchro rings in my trans. Is there a trick to hold them in place while putting the 'snap ring back on? First gear no problem. The others let's say I've been using a few choice words.
|
   |
 
|
  |
Replies
| brp914 |
May 8 2005, 12:07 PM
Post
#2
|
|
Unregistered |
it is sort of a pain, but I held down the sync ring/snap ring on a table top with one hand while using the snap ring pliers with the other. If that isn't working, perhaps you could put it all in a soft jawed vice. The gear is wider than where you need to apply force, but with a couple pieces of wood cut to size you should be able to hold things in place. Hope it helps.
|
|
|
|
Posts in this topic
ws91420 transmission guys May 7 2005, 11:57 AM
bondo Are they clean and dry? they "should" stick in pla... May 7 2005, 01:26 PM Bleyseng It is a bit tricky, but you must be using the wron... May 7 2005, 01:47 PM Dr. Roger I've found a touch of grease helps get lots of... May 7 2005, 05:39 PM ws91420 Okay guys I need a good answer. I get the ring in ... May 8 2005, 09:38 AM Bleyseng I am not at the shop but IIRC you have to get all ... May 8 2005, 11:43 AM
Red-Beard May 8 2005, 12:18 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 08:21 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.