Floor Pan Opinions |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Floor Pan Opinions |
sharper |
Jul 14 2003, 05:49 PM
Post
#1
|
Member Group: Members Posts: 146 Joined: 5-June 03 From: Woodstock, GA Member No.: 789 Region Association: South East States |
I obviously have some rust issues with my floorpan and wanted to get some opions. Basically the entire section under the center tunnel is rusted out and a few other little areas as well. A friend suggested cutting out the rusted areas and then "sandwich" the new floorpan underneath the old. It is a whole lot less prepwork if I just cut out the entire floor and weld in the new. What is everyone's opion on this?
|
Matt914MI |
Jul 15 2003, 11:17 PM
Post
#2
|
Newbie Group: Members Posts: 37 Joined: 6-February 03 From: Zeeland, MI Member No.: 260 Region Association: None |
I'm kind of in the same place right now...I'm replacing just the rear section on both sides of the pan. I also have to replace the rear section under the center tunnel, but I haven't cut the old out yet. I have some structural issues in the under-battery-tray area and then the Brad Mayeur kit to worry about first. I'll have lots of pics once I get some time to work on it. These 60 hour work weeks really cut down on car work time.
|
Lo-Fi Version | Time is now: 6th June 2024 - 09:11 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |