 /6 throttle linkage and bell crank, I need a picture |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Dr Evil |
 Jun 18 2005, 11:53 PM
Post
#1
|
|
Send me your transmission!  Group: Members Posts: 23,041 Joined: 21-November 03 From: Loveland, OH 45140 Member No.: 1,372 Region Association: MidAtlantic Region 
 |
I am trying to fit my throttle, and bell crank and I need a pic to show me how it all goes together. I think that my bell crank will not work. It is from a 911. Any info?
|
   |
 
|
  |
Replies
| Dr Evil |
Jun 19 2005, 12:23 PM
Post
#2
|
|
Send me your transmission! Group: Members Posts: 23,041 Joined: 21-November 03 From: Loveland, OH 45140 Member No.: 1,372 Region Association: MidAtlantic Region
|
Ok, here is the latest. I used the MAPP gas and heated the weakest looking joint until red hot. It broke free and I rotated it to the position necessary.
Now the problem I have is welding it in the new position. Is there a welding rod that I can use with the MAPP gas? I figure that there must be as I heated the joint up enough to break it loose. I tried plumbing solder, but it is not adhearing to the two pieces very well. |
|
|
|
Posts in this topic
Dr Evil /6 throttle linkage and bell crank Jun 18 2005, 11:53 PM
Dr Evil OK, I found the pic that I was looking for ( in a ... Jun 18 2005, 11:59 PM Dr Evil Here is mine Jun 19 2005, 12:03 AM McMark Looks like http://www.914wo... Jun 19 2005, 12:38 AM Dr Evil I'm hoping that it is low temp welded. I am go... Jun 19 2005, 10:05 AM Eddie Williams sounds like you need a brazing rod Jun 19 2005, 01:37 PM Dr Evil I just bought one, but I am concerned that the MAP... Jun 19 2005, 01:41 PM Dr Evil Its not pretty, but where the metal was thinner ar... Jun 19 2005, 02:01 PM Red-Beard MAPP gas is perfectly hot enough for brazing. Braz... Jun 19 2005, 02:15 PM Dr Evil Ta da! Jun 19 2005, 02:15 PM Dr Evil They were brazed to begin with, though. It should ... Jun 19 2005, 02:18 PM trekkor And here's the cool one... http... Jun 19 2005, 02:18 PM Aaron Cox cool deal.
does it run yet? Jun 19 2005, 02:19 PM Red-Beard <... Jun 19 2005, 02:24 PM Dr Evil Nope, I had to buy the rods. $3 and it is pre... Jun 19 2005, 02:29 PM
Dr Evil New problem http://www.914world.co... Jun 19 2005, 11:29 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 09:42 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.