 Can I see pics of your coolant lines, Under rockers or otherwise.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Dr. Roger |
 Jul 3 2005, 03:49 PM
Post
#1
|
|
A bat out of hell.  Group: Members Posts: 3,944 Joined: 31-January 05 From: Hercules, California Member No.: 3,533 Region Association: Northern California  |
For the V8. I just can't decide...
I do have speed bumps around my neighborhood and if I go under the center of the car they will get scraped. I don't want to use black iron. I'd like to go the rocker route but I've only seen the front of the lines ending up through the front wheel wells. Is there another way of doing this? |
   |
 
|
  |
Replies
| Brian Mifsud |
Jul 3 2005, 10:02 PM
Post
#2
|
|
Mechanical Engineer Group: Members Posts: 981 Joined: 3-March 03 From: Penngrove, CA Member No.: 384 Region Association: None |
blackpipe down the center of the car is quite a GOOD idea. As long as you run some etheylene glycol, rust is a non-issue (rest of engine is black iron....) Black Iron will not collapse if you hit a speed bump hard enough.. your sheetmetal will give first.
The V-8 Conversion listed on one of these pages with the black iron lines aft was a great idea. There isn't much exposure since he ran them in the indents in the bottom of the car anyhow. reconsider??? |
|
|
|
Posts in this topic
Dr. Roger Can I see pics of your coolant lines Jul 3 2005, 03:49 PM
John2kx Roger,
The attached pic may give you some ideas. ... Jul 3 2005, 06:08 PM tat2dphreak what is this coo-lant of which you speak? Jul 3 2005, 09:30 PM McMark Where's Rick's alien? Didn't he use r... Jul 4 2005, 12:30 AM rick 918-S Jul 4 2005, 01:47 AM hargray2 A cover would be nice to protect rubber lines.
It ... Jul 4 2005, 12:01 PM Dr. Roger Rick,
That's exactly what I have now. 2 piec... Jul 4 2005, 12:26 PM Andyrew Honestly they will all work fine. Your not going t... Jul 4 2005, 12:32 PM neo914-6 FYI, here are aluminum Boxster lines (dual rads).
... Jul 4 2005, 12:34 PM
914GT A few pictures of my lines. 3/4" steel pipe. The s... Jul 4 2005, 12:45 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 01:38 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.