 Oil cooler suggestions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DanT |
 Jul 4 2005, 02:09 AM
Post
#1
|
|
Going back to the Dark Side!  Group: Members Posts: 4,300 Joined: 4-October 04 From: Auburn, CA Member No.: 2,880 Region Association: None  |
Any suggestions/pictures of oil cooler setups/postitions? Anyone using electric fans or 3.2L Carrera type setup in the fender well with small radiator/shroud and fan?
If I buy the track car I am looking at the only mechanical issue that needs to be addressed is an oil cooler. Thanks |
   |
 
|
  |
Replies
| ArtechnikA |
Jul 4 2005, 06:08 AM
Post
#2
|
|
rich herzog Group: Members Posts: 7,390 Joined: 4-April 03 From: Salted Roads, PA Member No.: 513 Region Association: None |
not nearly as much room in a 914 fender as a 911; theirs are as wide as a 7" headlight, but ours are only as wide as the turn signal tunnel.
what works in a track car is a front-mounted cooler, with the exhaust air ducted either out over the top through a hole in the trunk lid, under the car a la 914/6GT or 911 RSR, or possibly through inner fenderwell vents like tha V8 guys get hot air away from the radiator. the Carrera cooler is good if you have access to factory parts cheap, or FluiDyne makes excellent coolers if you go aftermarket. (THe Earl's/SerckSpeed or Mocal coolers are widely available and cheaper, but not quite as efficient i don't think...) there are lots of pictures here showing front-mounted coolers, and the GT duct parts are available if you like that "factory-correct" look. fans won't help you at speed - and might actually hurt. fans are for AC cars in traffic; track cars don't really benefit.. |
|
|
|
Posts in this topic
Dan (Almaden Valley) Oil cooler suggestions Jul 4 2005, 02:09 AM
davep Rich is correct. At 5 MPH the airspeed will exceed... Jul 4 2005, 09:18 AM
neo914-6 Dan,
You are welcome to see the setup for a 2.7 o... Jul 4 2005, 10:06 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 01:29 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.