 Cylinder Head Temp Gauge, Step By Step Instructions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Allan |
 Jun 28 2005, 05:12 PM
Post
#1
|
|
Teenerless Weenie  Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California  |
Did a search but didn't find much. I'm looking for good, clear, step by step instructions on installing one. Car has no center console if that matters...........
|
   |
 
|
  |
Replies
| JmuRiz |
Aug 3 2005, 03:29 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,567 Joined: 30-December 02 From: NoVA Member No.: 50 Region Association: MidAtlantic Region 
|
OK, I'll look into a new sender...I thought that the resting place would be far-left. I'll check my setup and get a new sender and hopefully that'll fix it. Thanks!
|
|
|
|
Posts in this topic
Headrage Cylinder Head Temp Gauge Jun 28 2005, 05:12 PM
Mueller you could be the 1st to document it Jun 28 2005, 06:55 PM bd1308 i think it's just not in the same key with my ... Jun 28 2005, 06:59 PM Britain Smith For my Electromotive set-up, I was just going to u... Jun 28 2005, 07:07 PM Mueller ... Jun 28 2005, 07:47 PM bd1308 ... Jun 28 2005, 07:49 PM Headrage Jun 28 2005, 07:52 PM bd1308 you cant use the center console wiring to wire you... Jun 28 2005, 07:55 PM Headrage Jun 28 2005, 07:59 PM bd1308 ... Jun 28 2005, 08:06 PM Mark Henry A lot of the VDO senders came from the factory wit... Jun 28 2005, 08:38 PM SLITS Allan....as I remember, the first part of the wire... Jun 28 2005, 08:54 PM type47 use the VDO wiring harness that goes with the gaug... Jun 28 2005, 09:37 PM lapuwali There are two wires and you must run both of them ... Jun 28 2005, 10:09 PM Britain Smith How come the stock CHT sender is 1 wire? Does thi... Jun 29 2005, 02:24 PM tat2dphreak Aug 3 2005, 12:29 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 02:23 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.