 Help with rear brakes, what am I doing wrong? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Kevin@ojai.net |
 Aug 28 2005, 07:39 PM
Post
#1
|
|
Member  Group: Members Posts: 158 Joined: 9-July 03 From: Ventura & Chico, CA Member No.: 899  |
So, a few minutes ago I tried replacing my rear brake pads with out success. I was unable to retract the pistons far enough into the calipers to fit the new pads in. All I did during my failed attempt was remove the old pads, then pry against the pistons. This process has worked for me on other vehicles, but I had almost no luck on the 914. I was able to retract the pistons a little, but not nearly enough to get the new pads installed. What am I forgetting to do? What am I doing wrong?
-Kevin |
   |
 
|
  |
Replies
| John |
Aug 28 2005, 11:09 PM
Post
#2
|
|
member? what's a member? Group: Members Posts: 3,393 Joined: 30-January 04 From: Evansville, IN (SIRPCA) Member No.: 1,615 Region Association: None |
Good luck in getting the inner adjuster access plugs off/out if you have never done it before. Those can be a real bitch if the previous owner either never had them out or stripped them.
|
|
|
|
Posts in this topic
Kevin@ojai.net Help with rear brakes Aug 28 2005, 07:39 PM
Aaron Cox back out/in the adjusters.
venting clearance that ... Aug 28 2005, 07:48 PM davep I'd read up on rebuilding the calipers before ... Aug 28 2005, 07:56 PM Kevin@ojai.net Thanks, I'll give the vent adjusting screw a t... Aug 28 2005, 08:01 PM davep You will need the time to do the proper research. ... Aug 28 2005, 08:05 PM Kevin@ojai.net Is there more than the one adjuster on the wheelsi... Aug 29 2005, 12:09 AM JOHNMAN The outer adjuster only adjusts the outer piston. ... Aug 29 2005, 12:25 AM davep Just to get you started, in addition to all the go... Aug 29 2005, 09:21 AM Eric_Shea http://www.914world.com/bbs2/h... Aug 29 2005, 01:29 PM Kevin@ojai.net Wow! Thanks for the write up, very good infor... Aug 29 2005, 11:06 PM
davep Okay, but remember, you cannot force the piston ba... Aug 30 2005, 06:51 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 07:38 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.