 Securing the Rear Valence |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Tobra |
 Sep 2 2005, 06:13 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,453 Joined: 22-August 05 From: Sacramento, CA Member No.: 4,634  |
How is it supposed to be secured? I am thinking bolt with washer, through valence and body of car/rear bumper, then washer and nut. What size bolt, metric 10 mm maybe. Should nuts, bolts and washers be stainless or anything to prevent rust?
|
   |
 
|
  |
Replies
| 914GT |
Sep 2 2005, 06:48 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,101 Joined: 11-October 04 From: Tucson Member No.: 2,923 Region Association: Southwest Region |
I just installed one this afternoon. I basically did what you described and found some stainless steel screws. On the ends I used longer screws and some rubber washers similar to what was used originally.
|
|
|
|
Posts in this topic
Tobra Securing the Rear Valence Sep 2 2005, 06:13 PM
Tobra so rubber washer to protect sheet metal and bumper... Sep 2 2005, 07:46 PM ArtechnikA self-tapping screw, hex-head 4,8mm x 16 (914.6 - 1... Sep 4 2005, 07:23 AM Tobra I have been looking for these fasteners for a few ... Oct 1 2005, 07:28 AM ArtechnikA since it's only going into a speed nut, unless... Oct 1 2005, 07:55 AM Tobra dude, you rock
now I don't have to drive with... Oct 1 2005, 08:20 AM
ArtechnikA Oct 1 2005, 08:53 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 10:57 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.