Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Fuel Tank and Master Cylinder Leaks--HELP!!, DIY or Mechanic Job for newbie??
2pointOH
post Oct 5 2005, 04:36 PM
Post #1


Member
**

Group: Members
Posts: 51
Joined: 27-June 05
From: Columbus, OH
Member No.: 4,335



Hey all--

Smelling fuel and noticing fluid leaks under the 914 and had a mechanic inspect. Said I need to repair/recondition my fuel tank and my master cylinder is leaking fluid.

Regarding the tank--would it be better to have him repair this (send away and a 3-4 week project--don't know price yet), replce with NOS if available or try to recondition on my own??

Not sure on the Master Cylinder leaks--safe to drive or could my brakes fail at any time??

Also said 3 of my 4 wheels (custome Forgeline alloys) are bent and need fixed/reconditioned and then need to balance/align before repairing brakes--expected costs? Recomendations?

Thanks--John

User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
dmenche914
post Oct 5 2005, 08:01 PM
Post #2


Senior Member
***

Group: Members
Posts: 1,212
Joined: 27-February 03
From: California
Member No.: 366



Gawd!!! a few hundered for a tank!!!! I parted with one not too long ago for about $60, nice one too, sender and everything.

leaky master means don't drive the car until it is resolved.

Gas tank may or may not be bad, you need to raise the car, remove the two small, and two large bolts, ans drop the coverplate. This will expose the hoses and bottom of the tank. You also can get a very good very of the inside of the tank by removing the filler assembly, just remove the half dozen or so little bolts around the filler hole, (and remove the expansion tank) and you get a big four inch or so opening to look into, also you can look inside thru the float gage hole.

when messing with the hoses, under tank, do it outside, not in the garage, or near any source of flame/spark Wrong tug or bend on the possibly Brittle plastic lines that the rubber hoses hook too, and the entire tank starts pouring out ont eh floor, not pretty in the garage with a water heater! You can't even push the car out cause its up on stands! FIRE.

User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 20th June 2024 - 12:14 PM