Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> how to drain a tranny?, how do i do it?
shaggy
post Oct 30 2005, 08:16 PM
Post #1


mechanic/welder/fabricator
***

Group: Members
Posts: 702
Joined: 26-September 05
From: Gilbert, AZ
Member No.: 4,869
Region Association: None



my tranny is leaking from that plate in the rear that is held on with 4 10mm nuts

its not leaking really bad but every day there is some oil
i know its coming from there cuz i look down there and i can see that there are drops of oil forming opn those screws

i have tightened those nuts and found no result

is it possible that my seal is bad?

if so could i just drain my tranny take that plate off clean both surfaces put a new seal in and but it back together?
then re fill it?

how exactly do i drain and refill a tranny properly?
what is the size of that massive hex wrench?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
ws91420
post Oct 30 2005, 08:24 PM
Post #2


Yes I have one a Lensley 914
****

Group: Members
Posts: 2,063
Joined: 10-September 03
From: Ruther Glen,VA (halfway between sticks and civilization)
Member No.: 1,137
Region Association: MidAtlantic Region



17 mm I think and you wont get a complete drain if the trans is still in the car. I bought a set of four large metric hex sockets at auto zone and I know it is one of those.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 2nd June 2024 - 03:48 PM