 GT brass tubes to oil cooler, Outside diameter |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| michel richard |
 Nov 1 2005, 07:58 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,291 Joined: 22-July 03 From: Longueuil, Québec Member No.: 936  |
Does anybody know the outside diameter of the brass tubes that run along the driver side longitudinal on the original 914/6 GT cars ?
TIA |
   |
 
|
  |
Replies
| davep |
Nov 1 2005, 09:32 PM
Post
#2
|
|
914 Historian Group: Benefactors Posts: 5,332 Joined: 13-October 03 From: Burford, ON, N0E 1A0 Member No.: 1,244 Region Association: Canada  |
There are rubber bushings for the holes in the sill supports. I'd guess the pipe OD is the same as the Bushing ID. Now if I can find my bushings, you may have an answer.
|
|
|
|
Posts in this topic
michel richard GT brass tubes to oil cooler Nov 1 2005, 07:58 AM
ChicagoPete How quickly do you need an answer on this? The gu... Nov 1 2005, 07:38 PM michel richard Peter,
I must say I did'nt mean to bother Arm... Nov 1 2005, 08:04 PM michel richard Today I figured that the most important thing I ne... Nov 1 2005, 09:12 PM michel richard The forward part: Nov 1 2005, 09:12 PM michel richard And the jack point after I cut it.
I now want to... Nov 1 2005, 09:14 PM michel richard Oops, I meant to put these in the main thread. I... Nov 1 2005, 09:15 PM db9146 Michel,
Did you have to fab the front oil line su... Nov 1 2005, 10:05 PM Jeroen why did you cut out the jack post?
didn't the ... Nov 1 2005, 10:59 PM michel richard Dave,
On the 4 cylinder cars, the tubes that go d... Nov 2 2005, 06:26 AM 9146986 You probably don't want to use the original si... Nov 2 2005, 07:25 AM michel richard Perry,
If you could, I would be grateful. It... Nov 2 2005, 08:16 AM
davep Michel,
I realize the evap lines run through the ... Nov 2 2005, 09:31 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th November 2025 - 05:00 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.