cleaning my engine, and maintnence Options

[shaggy]

so i dropped the engine finally

i have it out in my grage now and tomorrow ill start cleaning it up

heres my to do list as of yet, please if i missed anything chime in:

degrease engine

check valve cover gaskets

check for oil leaks (push rods mainly)

change oil filter assembly

put in new impeller(mine now has a missing fin, if any one has one and can sent it to my in az by friday please pm me)

replace timing belt(with impeller)

change fuel filter

change tranny ground strap(mine was trashed)

change fuel lines(where needed)

put clamps on intake runners

change spark plugs

clean engine bay

clean hell holes( por 15? anyone know anything about it?)

replace missing engine tin( im missing the front passenger tin now that my ac compresser is out of anyone anyone has one and can have it to az by friday please pm me)

neaten up electrical system(not replace anything)


so did i miss anything?
if so please tell me
id like to have my engine ready to go back in by next friday so im trying to control what im going to do

[shaggy]

i took the rest of the shrowd off and replaced the oil filter assembly
and then put it back together

there were some flaps/bellows in there and i cna figure out how they go back
i have them lined up but the passenger side wont close and i cant figure out how the spring fits back in its loaded position

(IMG:http://www.geocities.com/shaggy_nine14/engine/IMG_1770.jpg)
theres the flap on the driver side(i cant get it closed, if it does close)
(IMG:http://www.geocities.com/shaggy_nine14/engine/IMG_1771.jpg)
theres the flap that stays in place on the passenger side, just behind out of camra view there is a cut in the tin to allow air to flow through the oil cooler
(IMG:http://www.geocities.com/shaggy_nine14/engine/IMG_1772.jpg)
the screw driver is pointing to the rod that connects the driver flap to the rest of the car (sorry the driver is hard to see)
(IMG:http://www.geocities.com/shaggy_nine14/engine/IMG_1773.jpg)
theres the spring that should keep the flap down, i think. how shoud that be loaded and be sitting?
(IMG:http://www.geocities.com/shaggy_nine14/engine/IMG_1774.jpg)
theres a tab that comes off the rear postion of the housing that holds the rod in place
(IMG:http://www.geocities.com/shaggy_nine14/engine/IMG_1778.jpg)
thats something that holds the rod down. its in the passenger side vent thingie

does anyone know how thay are suppost to go together?
how does this all fit back together?

they haynes manual dosent have anything about this
and i dont know what they are called to search it