 Brake cyl. hone, push tube seals |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| toon1 |
 Nov 11 2005, 09:03 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,849 Joined: 29-October 05 From: tracy,ca Member No.: 5,022  |
I am replacing the p/r tube seals in a 1.7 and am wondering if it is possible to use a brake cyl. hone to clean up the bores on the head?
|
   |
 
|
  |
Replies
| bd1308 |
Nov 11 2005, 09:26 PM
Post
#2
|
|
Sir Post-a-lot Group: Members Posts: 8,020 Joined: 24-January 05 From: Louisville,KY Member No.: 3,501 |
if its a early 1.7, youd better hone good....the smaller pushrod tube seals are extinct now. only the larger 1.8,2.0 and late 1.7 seals are available. This requires a switch-over if you have the early ones.
b |
|
|
|
Posts in this topic
toon1 Brake cyl. hone Nov 11 2005, 09:03 PM
Mark Henry The holes for the pushrods don't line up with ... Nov 11 2005, 09:40 PM bd1308 http://w... Nov 12 2005, 06:08 AM
Cap'n Krusty Nov 12 2005, 03:50 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 09:29 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.