 changin out venturis |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| D0ctorg00se |
 Nov 14 2005, 05:36 PM
Post
#1
|
|
Newbie  Group: Members Posts: 7 Joined: 31-October 05 From: Blacksburg, VA Member No.: 5,032  |
Ok so im changing my 36mm venturis for 32mm venturis on my set of EMPI HPMX 44's. Thing is i've never done this before and was looking for advice/guidance on doing so. Anyone changed theirs out that could give me some help?
|
   |
 
|
  |
Replies
| lapuwali |
Nov 14 2005, 06:18 PM
Post
#2
|
|
Not another one! Group: Benefactors Posts: 4,526 Joined: 1-March 04 From: San Mateo, CA Member No.: 1,743  |
I've never even seen a pair of the EMPIs, but if they really are Weber clones, then you have to remove the top plate, then remove the secondary venturies (the small tubes hanging in the throats, which just pull out), then there are two pinch bolts on the side of the body (opposite side from the mixture screws), which hold the main venturies in place. Loosen those, and the venturies pull out. Their size should be stamped on them. Reassemble and you're ready to go.
|
|
|
|
Posts in this topic
D0ctorg00se changin out venturis Nov 14 2005, 05:36 PM
Joe Ricard Piece f cake on my Webers. take apart carbs, pull ... Nov 14 2005, 05:58 PM
MattR If you're doing this with the carbs on the car... Nov 14 2005, 06:24 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th July 2025 - 11:14 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.