![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
BenNC |
![]()
Post
#1
|
Member ![]() ![]() Group: Members Posts: 140 Joined: 7-February 03 From: Cary, NC Member No.: 267 ![]() |
The flange for the CV boots that I bought came with 6 holes. Knowing that only 4 of these would be filled with bolts, I put a bead of gasket material to seal the grease in. This seems to have worked for one side, but the other is steadily coating the underside of my trunk with CV grease.
Any thoughts other than to clean it up and try again? Thanks |
![]() ![]() |
BenNC |
![]()
Post
#2
|
Member ![]() ![]() Group: Members Posts: 140 Joined: 7-February 03 From: Cary, NC Member No.: 267 ![]() |
There are roll pins on the solid part of the joint that meets the flange (sorry, lacking proper terminology), but they are flush with the surface. The original boots that I took off only had four holes in the flange.
Same thing on the donor car for the engine/tranny. Do I need to replace the roll pins? |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 16th June 2024 - 01:52 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |