Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Black/purple Tach Wire..question, using an MSD.. (w/six engine)
DougC
post Nov 28 2005, 04:55 PM
Post #1


Senior Member
***

Group: Members
Posts: 949
Joined: 6-July 04
From: Dallas, TX
Member No.: 2,307



The Black/Purple wire usually (4 cyl stock) goes to the "-" side of the coil, right? So I have my MSD unit hooked up and the car (6 cyl, MSD) idles and runs fine but the tachometer isn't working.. actually the blk/pur wire isn't hooked up right now either. So, I have a tach adapter and I'm assuming that the "-" wire from it will go to the neg side of the coil with the blk/pur wire from the harness. Does that sound logical? I've researched this quite a bit today so any insite would be appreciated.

Doug C
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
TimT
post Nov 28 2005, 07:56 PM
Post #2


retired
****

Group: Members
Posts: 4,033
Joined: 18-February 03
From: Wantagh, NY
Member No.: 313



oops misread the post

yes tach out from MSD goes to black/purple, this signal may have to be conditions by the tach adapter, depending on the year of the vehicle...
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 1st June 2024 - 11:18 PM