 winter project (maybe), i must be crazy |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| double-a |
  Nov 30 2005, 11:04 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 987 Joined: 15-September 03 From: vancouver, wa, usa Member No.: 1,162 Region Association: Pacific Northwest  |
i've got a few months to kill until i need to get the bodywork and paint done on the car, so i got to thinking... what do 4-lug mahles look like all polished up? i've got an unshod spare, why not find out?
now i know why i haven't seen many polished mahles. here's what a stock wheel looks like with 30 years of crud, curb rash and two or three coats of paint: Attached image(s) 
|
   |
 
|
  |
Replies
| SLITS |
Dec 1 2005, 09:17 AM
Post
#2
|
||
|
"This Utah shit is HARSH!" Group: Benefactors Posts: 13,602 Joined: 22-February 04 From: SoCal Mountains ... Member No.: 1,696 Region Association: None  |
Cast - - - good strength, grainy (porous) finish, cheapest method Pressure cast - - - better strength, less grainy finish, Forged - - - highest strength, fine grain (smooth) finish, most expensive It all revolves around the cost to make the part, the finish and strength desired..IMO. |
||
|
|
|
||
Posts in this topic
double-a winter project (maybe) Nov 30 2005, 11:04 PM
double-a 20 (or so) hours later, voila. Nov 30 2005, 11:06 PM double-a vive la difference. Nov 30 2005, 11:06 PM double-a mahles are beset with the most wonderful array of ... Nov 30 2005, 11:16 PM jonwatts It's much less of a cheapo wheel now that it... Nov 30 2005, 11:21 PM double-a where do i send the check? it doesn't look ter... Nov 30 2005, 11:30 PM thomasotten Looks good! Dec 1 2005, 01:10 AM mikey Looks very nice after the polishing.
Are the 4-lu... Dec 1 2005, 01:26 AM SLITS Dec 1 2005, 05:21 AM MecGen Great Job Man http://www.... Dec 1 2005, 05:45 AM double-a Dec 1 2005, 08:57 AM mudfoot76 Explanation of different metal forming techniques
... Dec 1 2005, 09:06 AM
double-a ok, might as well do the other four. i'll need... Dec 1 2005, 09:54 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th June 2024 - 04:11 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.