Hell Hole Rust discovered, go me... |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Hell Hole Rust discovered, go me... |
VaccaRabite |
Dec 9 2005, 04:18 PM
Post
#1
|
En Garde! Group: Admin Posts: 13,465 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region |
So, I had thought that spot through the firewall was isolated. I was wrong.
(IMG:http://static.flickr.com/35/71884394_abb0fd7653.jpg) (IMG:http://static.flickr.com/34/71884388_3b4916eb8b.jpg) I took out the battery tray, as it was looking ratty. After I had it out, I started probling with a screw driver and a hammer to see what was surface rust, and what was problem rust. It seems like the inner fender has issues in the hell hole, as does the engine surround. But the long is solid. I was really whaleing at it with the hammer and screwdriver, and nothing went through. Also, above the hell area, there is surface rust, but I could not probe through that either. How do I fix this? Do I need to take off the outer quarter panel? If so, exactly how do I go about doing that? At this point, should I fix it and weld in a new battery tray there, or move the battery to a box in the back? This is not the first time that the battery box had been replaced. It looked like the top to the tray had been rusted out, cut out, and a new top welded in a long time ago. The person who welded it in, also managed to burn through the inner pass-side quarter panel on one of his tack welds, so that area was weak too. maybe a waek spot the size of a quarter. And, I went out into the garage tonight with the intentions of pulling out my crumbly old fuel lines.... Zach |
VaccaRabite |
Dec 13 2005, 05:32 PM
Post
#2
|
En Garde! Group: Admin Posts: 13,465 Joined: 15-December 03 From: Dallastown, PA Member No.: 1,435 Region Association: MidAtlantic Region |
OKay, today I tried to cut out the rust.
(IMG:http://static.flickr.com/20/73320340_9c4d560bdb.jpg) The red was the outline of what I wanted to cut away. Obviously, I ran into touble, as I am here. I was using an angle grinder with a cut off wheel. I was not able to get very far into the hell hole with it though. Its too big, and I can't get the cut wheel in to make the cuts. I _DON'T_ want to cut out the long. It is solid. I want to take the metal out from around it. Right now my only options are angle grinder, or a dremel and cutting wheel (which I don't see really working either). I don't have a sawzall. How do you folks get in there to make the cut? What is the right tool for the job? I don't want to buy tools I don't need. Zach |